Lupe Fischer Table Saw August 24th, 2018 - 14:06:32
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
Most table saws - other than small bench top models - are equipped with induction type motors in the 1 - 5 HP range. On larger saws, you'll most often find a "totally enclosed, fan cooled" (TEFC) induction motor. A TEFC motor is designed for continuous duty and is sealed against dust and other contaminants - a significant advantage in a woodshop.
Some saws shield the blade in a casing underneath the saw table and suck the dust out directly from there. Others slant the floor of the saw cabinet towards a dust collection port. Many just allow the sawdust to accumulate on the floor under the saw until you clean it out. You will always have some cleaning of the interior to do. Perhaps you won't wait until the sawdust has totally encased the trunnion gears packing itself up to the bottom of the table top. You will need to connect the saw to a dust collector through its dust port. The suction of the dust collector should be about 350 CFM for a 10" saw and more for a larger saw.
Most table saws use the miter gauge and miter slot system to allow for crosscutting. A miter gauge consists of a cast metal protractor head attached to a length of metal bar. The bar rides in corresponding "miter slot" in the table saw's surface. Protractor on the "no frills" miter gauges that come with most table saws can be set to crosscut stock at any angle between 90 and 30 degrees and, if well made, do a serviceable job with most "routine" crosscutting.
A table saw is the most common piece of large woodworking equipment found in shops around the world. Table saw are very versatile, and if you can only have one piece of woodworking equipment, a rigid table saw is probably the best one to choose. These more portable types of table saws offer versatility and ease of use with the convenience of portability.