Home / Table Saw / Miter Saw Table Harbor Freight / Miter Saw Table Harbor Freight Mobile Miter Saw Stand Harbor Freight Miter Saw Table Harbor Freight Portable Miter Saw Table Harbor Freight Portable Miter Saw
Lindsey Weiss Table Saw August 09th, 2018 - 16:38:59
There is a rule that says, "Never stand directly behind a horse or a table saw." Sooner or later every table saw operator will do something stupid that causes a kickback. If the operator makes it a practice to avoid standing where the kickback will occur behind the blade, he or she will probably avoid the severe injury that can be inflicted by a flying piece of wood striking the face, neck, chest or arms of the woodworker.
The bench top model is preferred for those who are looking for a table saw that is portable and less expensive; however, remember that you always get what you pay for. The bench top saw has the least amount of capability out of any of the table saws. With the decreased size and weight of the saw, it is less durable and there are greater restrictions of the size of projects one can do.
Motor horsepower and blade size are closely related. The larger the blade, the more horsepower you will need to cut, at full blade height, through a piece of wood. Too much power is never a problem. Too little power can cause the saw to bind, slow down and even stop in the middle of a cut. This is not good, nor is it safe.
If you consider that a sheet of plywood measures 48" in width, I would think that you might want to opt for a 50-inch rip as opposed to the slightly less expensive 30" rip capacity. You might want to rip off only one inch from that sheet of plywood and, while doing that, you will want the plywood to be fully supported. You might want to crosscut a sheet of plywood into two 48" pieces. You also should consider the rip space to the left of the blade: The wider, the better. Sometimes, you might want to accomplish tasks that require the fence to be put over to the left side of the blade.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
Have Something to Say on Miter Saw Table Harbor Freight Mobile Miter Saw Stand Harbor Freight Miter Saw Table Harbor Freight Portable Miter Saw Table Harbor Freight Portable Miter Saw