Johanna Soto Table Saw August 08th, 2018 - 13:07:14
Some saws shield the blade in a casing underneath the saw table and suck the dust out directly from there. Others slant the floor of the saw cabinet towards a dust collection port. Many just allow the sawdust to accumulate on the floor under the saw until you clean it out. You will always have some cleaning of the interior to do. Perhaps you won't wait until the sawdust has totally encased the trunnion gears packing itself up to the bottom of the table top. You will need to connect the saw to a dust collector through its dust port. The suction of the dust collector should be about 350 CFM for a 10" saw and more for a larger saw.
The ideal solution is to have enough shop space so that you will never have to move your saw around at all. In this situation, you can construct an outfeed table to support large work pieces and long lumber as they leave the back edge of the table saw table. Ideally, depending on space available, you should build this outfeed table so that it extends eight feet or more in back of the blade. You can use the space underneath the table for lumber storage and/or drawer space. The table can also serve as a work bench for the construction of large cabinets and tables. You can use it for pipe clamp glue-ups and spray painting layout, as well.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
Also known as the open-stand saw, the contractor saw is heavier and more durable than the bench top saw. Its circular saw is mounted on a heavy table with an open set of legs. This type of saw is usually preferred for those who have a tool shed at home since it is moderately-priced and does not require any extra voltage than is provided in a regular outlet. While this model is heavier and less portable than the bench top model, the contractor table saw is still usually moved from job to job (most contractor saws come with wheel attachments to make this easier).
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.