Home / Table Saw / Building A Table Saw Table / Building A Table Saw Table As Well As Diy Table Saw Table Extension With Build A Table Saw Table Extension Plus Building A Wood Table Saw Stand Together With
Edith Hart Table Saw August 28th, 2018 - 15:03:44
The size of the cast iron table saw top is also important: the larger the better. When you are sawing large objects, you want as much flat table surface as you need to support the work piece flat to the blade for accuracy. Larger table size is usually accomplished by attaching cast-iron table wings to the edge of the main table. These wings must be as flat as the table and the seam they create must be aligned so that the top of the wing is flush to the table saw table along its entire length.
Beginning at the bottom, the table saw base houses the working parts of the saw, including the trunnions, the arbor assembly, the sector gears, and sometimes the motor. On some saws, the base is a "cabinet" type, meaning that a fully enclosed base extends all the way to the floor. Other saws have an open base, meaning that the base consists of a metal box that surrounds the internal working parts of the saw on four sides, but not the bottom. Open base saws have legs that extend downward from the bottom of the base to the floor.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
Another important safety device is the magnetic switch. This device protects you after an electrical power failure. If the power fails and you have a regular switch, the saw will come back on when the power comes back on. If you were to be near the blade at the time, this could be disastrous. A magnetic switch will not allow the saw to start again until you press the button. The location of the switch is also important. It should be right out front where it can be quickly accessed by a hand, foot or knee in the event of an emergency. The off button should be wide, red in color and should extend outside of the switch box like a mushroom for fast access.
The rip fence guides the wood as it is being ripped (cut along its length) and can be positioned to any width of cut within the saw's range. The fence rides on fence rails attached to the front and rear edge of the table. Ideally, the system keeps the fence perfectly parallel to the plane of the blade, regardless of where the fence is positioned.
Care to Shout Your Thoughts on Building A Table Saw Table As Well As Diy Table Saw Table Extension With Build A Table Saw Table Extension Plus Building A Wood Table Saw Stand Together With
Posts Related To Building A Table Saw Table