Edith Hart Table Saw August 28th, 2018 - 14:53:54
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
This second type of table saw is heavier and bigger in size compared to the first one. But still it can be relocated everywhere in work location. With this reason, it is definitely more durable and its work capability is more efficient. This is reasonably priced also has an attached rest or stand but also comes in wheels. This is recommended especially for homeowners who have standard electrical circuits which are needed to handle sufficient power to operate it. This is also certainly for you if you have a tool shack in your home.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
At least one, but preferably two or more access doors should be provided leading into the cabinet of the table saw. The one you will use most often will be for cleaning out the interior of sawdust. Another should give easy access to the motor, trunnion and belts for adjustment and repair. Many saws provide a removable access panel instead of a second door. That's fine for occasional motor, arbor, belt and trunnion access but you will want the sawdust door to open and close easily.
Care to Shout Your Thoughts on Part 2 Build A Homemade Table Saw Extension With A Router Part 2 Build A Homemade Table Saw Extension With A Router Table Built In Part 2