Carla Cain Table Saw August 28th, 2018 - 09:50:44
Cabinet table saws have the circular saw attached to a table with a cabinet. It is the largest and the heaviest of the table saws and therefore is not moved around like the other table saws. The cabinet table saw is more durable and has less vibration which makes for a smoother cut. However, the cabinet saw is more expensive than the other types of saws and usually requires the installation of a heavy circuit. The cabinet saw also has a height and tilt adjustment feature and has better dust collection than the other models.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
I'd like to take a minute to talk about the features that you should be looking for and what these features will mean to you after you unpack and set up your new table saw. These features include: motor horsepower, blade size, trunnion construction, tabletop flatness, tabletop size, arbor size and arbor bearings, sawdust extraction, ease of operation including raising, lowering and tilting the blade, tilt of the blade (left or right), the necessity of a magnetic switch and the importance of its location, ease of access to the interior of the cabinet, accuracy and ease of operation of the fence, the amount of rip space to the right and the left of the blade, safety features and table saw mobility around the shop. In addition to the table saw itself, you may want to construct an outfeed table around the back of the saw, if space permits. We'll talk about that, as well.
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
Leave Your Reply on R4512 Table Saw Ridgid Table Saw Accessories R4512 Router R4512 Table Saw Dado Insert Ridgid R4512 Table Saw Zero Clearance Insert Ridgid R4512 Table Saw
Posts Related To R4512 Table Saw