Home / Table Saw / Kobalt 10 Table Saw / Kobalt 10 Table Saw As Well As Kobalt 10 Inch Portable Table Saw With Kobalt 15 Amp 10 In Table Saw Accessories Plus Kobalt 10 Table Saw Assembly Together With
Trina Sanchez Table Saw August 02nd, 2018 - 04:29:41
Motor horsepower and blade size are closely related. The larger the blade, the more horsepower you will need to cut, at full blade height, through a piece of wood. Too much power is never a problem. Too little power can cause the saw to bind, slow down and even stop in the middle of a cut. This is not good, nor is it safe.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
At least one, but preferably two or more access doors should be provided leading into the cabinet of the table saw. The one you will use most often will be for cleaning out the interior of sawdust. Another should give easy access to the motor, trunnion and belts for adjustment and repair. Many saws provide a removable access panel instead of a second door. That's fine for occasional motor, arbor, belt and trunnion access but you will want the sawdust door to open and close easily.
The trunnion is the mechanism inside the cabinet which is responsible for both raising and lowering the blade and tilting the blade for bevel cuts. It is controlled from the outside of the saw by two separate wheels or cranks: one for raising and lowering the blade (usually found on the front of the cabinet) and the other for tilting the blade (either left or right, depending on the saw) which is usually, but not always, located on the side of the cabinet.
The quality of the table saw surface (or "bed") is extremely important to the overall performance of the machine. The table surface needs to be reliably flat and rigid to properly support the workpiece during a cut. As one of the most massive parts of the saw, the table surface also plays a major role in absorbing vibration. Because of the need for mass, rigidity and flatness, cast iron is the material of choice for the top of a table saw. On a quality saw, the table is made using a hefty quantity of cast iron and state-of-the-art foundry methods. The end result of the casting process is then precision ground to flatness in the .0005'' tolerance range.
Have Something to Say on Kobalt 10 Table Saw As Well As Kobalt 10 Inch Portable Table Saw With Kobalt 15 Amp 10 In Table Saw Accessories Plus Kobalt 10 Table Saw Assembly Together With