Courtney White Table Saw July 28th, 2018 - 20:04:11
Saws specifically designed for hobbyists and home use are usually outfitted with motors under 3 HP and can be operated on standard 110 volt residential circuitry. In general, motors in this class are powerful enough for routine cutting of sheet goods and hardwoods up to 1'' thick. Professional-class saws, on the other hand, have motors in the 3- 5 HP range and require a 220 volt power supply. Motors in this category are designed to stand up to hours of continuous duty, and have enough power to cut thick, heavy hardwood stock without bogging down.
One table saw manufacturer I know believes in "aging" its cast iron machine table tops before milling them flat. The tops are cast and then left outside in a "bone yard" to bend, bow, warp and twist in the sun and rain for a year or so. Then, they are brought inside where all the rust is removed and the table top is ground absolutely flat and polished to sheen. The theory is that the metal needs to settle into a place where all post-casting movement has ceased and that the table should not be ground flat before this is done. Otherwise, the table may move out of absolute flatness after it is part of your new table saw and that it not at all desirable. Why? Because the flatness of your table saw top will determine the accuracy of your cuts. Be sure to check your new table saw for table flatness with a straightedge on or before delivery and afterwards from time to time. Lay the rule across the table top at all angles and check for daylight under the rule or rocking of the straightedge on the table top.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
A table saw is the most common piece of large woodworking equipment found in shops around the world. Table saw are very versatile, and if you can only have one piece of woodworking equipment, a rigid table saw is probably the best one to choose. These more portable types of table saws offer versatility and ease of use with the convenience of portability.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.