Terry Morin Table Saw August 22nd, 2018 - 13:17:35
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
There is a rule that says, "Never stand directly behind a horse or a table saw." Sooner or later every table saw operator will do something stupid that causes a kickback. If the operator makes it a practice to avoid standing where the kickback will occur behind the blade, he or she will probably avoid the severe injury that can be inflicted by a flying piece of wood striking the face, neck, chest or arms of the woodworker.
At least one, but preferably two or more access doors should be provided leading into the cabinet of the table saw. The one you will use most often will be for cleaning out the interior of sawdust. Another should give easy access to the motor, trunnion and belts for adjustment and repair. Many saws provide a removable access panel instead of a second door. That's fine for occasional motor, arbor, belt and trunnion access but you will want the sawdust door to open and close easily.
Saws specifically designed for hobbyists and home use are usually outfitted with motors under 3 HP and can be operated on standard 110 volt residential circuitry. In general, motors in this class are powerful enough for routine cutting of sheet goods and hardwoods up to 1'' thick. Professional-class saws, on the other hand, have motors in the 3- 5 HP range and require a 220 volt power supply. Motors in this category are designed to stand up to hours of continuous duty, and have enough power to cut thick, heavy hardwood stock without bogging down.
A hybrid table saw is a lot like the contractor saw with a few key differences. For one thing, it is much more compact than the contractor saw and does not require as much room in your tool shed. The hybrid table saw also offers some of the features of the cabinet saw. With its solid and heavy base, it has the lower vibration of a cabinet saw along with dust control. A contractor saw or a hybrid saw of good quality suits the needs of most woodworkers.