Trina Sanchez Table Saw August 18th, 2018 - 14:15:55
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
Beginning at the bottom, the table saw base houses the working parts of the saw, including the trunnions, the arbor assembly, the sector gears, and sometimes the motor. On some saws, the base is a "cabinet" type, meaning that a fully enclosed base extends all the way to the floor. Other saws have an open base, meaning that the base consists of a metal box that surrounds the internal working parts of the saw on four sides, but not the bottom. Open base saws have legs that extend downward from the bottom of the base to the floor.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
This last type of table saw also appealing to the customer base on table saw reviews. It is maybe due to its features that are somewhat similar to those of the cabinet and contractor table saw. Just like the cabinet table saw, it also has a solid base with also lesser vibration and provides dust control. It is also compact just like the contractor saw but the thing is that it is much compressed than the first mentioned. However, this saw inclines to weigh less than a cabinet table saw but heftier than the contractor table saw. This makes it intended for most of woodworkers.
I'd like to take a minute to talk about the features that you should be looking for and what these features will mean to you after you unpack and set up your new table saw. These features include: motor horsepower, blade size, trunnion construction, tabletop flatness, tabletop size, arbor size and arbor bearings, sawdust extraction, ease of operation including raising, lowering and tilting the blade, tilt of the blade (left or right), the necessity of a magnetic switch and the importance of its location, ease of access to the interior of the cabinet, accuracy and ease of operation of the fence, the amount of rip space to the right and the left of the blade, safety features and table saw mobility around the shop. In addition to the table saw itself, you may want to construct an outfeed table around the back of the saw, if space permits. We'll talk about that, as well.