Home / Table Saw / Circular Saw Or Table Saw / Circular Saw Or Table Saw And Circular Saw Table Saw Conversion With Circular Saw Vs Table Saw Plus Circular Saw Table Saw Combo Together With Circular Saw
Tammy Branch Table Saw August 28th, 2018 - 17:45:32
The saw should come with a Biesemeyer or similar type fence included in the purchase price. This type of fence locks and aligns itself to a rectangular tube attached to the front of the saw table when you press down on a handle. Fence accuracy and ease of operation will be important every time you touch your table saw and so a cheap fence is no bargain. The fence will probably read measurements along a stick-on measuring tape on the top of the front fence rail tube. You will need to carefully adjust the fence for accuracy. Instructions of how to do this should come with the set-up instructions for the saw.
The ideal solution is to have enough shop space so that you will never have to move your saw around at all. In this situation, you can construct an outfeed table to support large work pieces and long lumber as they leave the back edge of the table saw table. Ideally, depending on space available, you should build this outfeed table so that it extends eight feet or more in back of the blade. You can use the space underneath the table for lumber storage and/or drawer space. The table can also serve as a work bench for the construction of large cabinets and tables. You can use it for pipe clamp glue-ups and spray painting layout, as well.
The quality of the table saw surface (or "bed") is extremely important to the overall performance of the machine. The table surface needs to be reliably flat and rigid to properly support the workpiece during a cut. As one of the most massive parts of the saw, the table surface also plays a major role in absorbing vibration. Because of the need for mass, rigidity and flatness, cast iron is the material of choice for the top of a table saw. On a quality saw, the table is made using a hefty quantity of cast iron and state-of-the-art foundry methods. The end result of the casting process is then precision ground to flatness in the .0005'' tolerance range.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
Some saws shield the blade in a casing underneath the saw table and suck the dust out directly from there. Others slant the floor of the saw cabinet towards a dust collection port. Many just allow the sawdust to accumulate on the floor under the saw until you clean it out. You will always have some cleaning of the interior to do. Perhaps you won't wait until the sawdust has totally encased the trunnion gears packing itself up to the bottom of the table top. You will need to connect the saw to a dust collector through its dust port. The suction of the dust collector should be about 350 CFM for a 10" saw and more for a larger saw.
Leave Your Reply on Circular Saw Or Table Saw And Circular Saw Table Saw Conversion With Circular Saw Vs Table Saw Plus Circular Saw Table Saw Combo Together With Circular Saw
Posts Related To Circular Saw Or Table Saw