Home / Table Saw / Circular Saw Or Table Saw / Circular Saw Or Table Saw Circular Saw Vs Table Saw Vs Mitre Saw Circular Saw Table Saw Conversion Circular Saw Vs Table Saw Blade Circular Saw Table Saw For
Tammy Branch Table Saw August 28th, 2018 - 16:47:01
A table saw is the most common piece of large woodworking equipment found in shops around the world. Table saw are very versatile, and if you can only have one piece of woodworking equipment, a rigid table saw is probably the best one to choose. These more portable types of table saws offer versatility and ease of use with the convenience of portability.
Another important safety device is the magnetic switch. This device protects you after an electrical power failure. If the power fails and you have a regular switch, the saw will come back on when the power comes back on. If you were to be near the blade at the time, this could be disastrous. A magnetic switch will not allow the saw to start again until you press the button. The location of the switch is also important. It should be right out front where it can be quickly accessed by a hand, foot or knee in the event of an emergency. The off button should be wide, red in color and should extend outside of the switch box like a mushroom for fast access.
The motor, trunnions, arbor assembly, and gearing make up the essential mechanical components of the saw. These quality and robustness of these components varies considerably and can greatly impact the durability of the saw, its capacity for cutting heavy stock and its ability to stay in adjustment and hold settings.
I'd like to take a minute to talk about the features that you should be looking for and what these features will mean to you after you unpack and set up your new table saw. These features include: motor horsepower, blade size, trunnion construction, tabletop flatness, tabletop size, arbor size and arbor bearings, sawdust extraction, ease of operation including raising, lowering and tilting the blade, tilt of the blade (left or right), the necessity of a magnetic switch and the importance of its location, ease of access to the interior of the cabinet, accuracy and ease of operation of the fence, the amount of rip space to the right and the left of the blade, safety features and table saw mobility around the shop. In addition to the table saw itself, you may want to construct an outfeed table around the back of the saw, if space permits. We'll talk about that, as well.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
Have Something to Say on Circular Saw Or Table Saw Circular Saw Vs Table Saw Vs Mitre Saw Circular Saw Table Saw Conversion Circular Saw Vs Table Saw Blade Circular Saw Table Saw For