Home / Table Saw / Table Saw Station Plans / Table Saw Station Plans Table Saw Router Station Plans Table Saw Station Plans Pdf Table Saw Workbench Plans Pdf New Yankee Workshop Table Saw Station Plans
John Frye Table Saw August 28th, 2018 - 10:58:02
Some saws shield the blade in a casing underneath the saw table and suck the dust out directly from there. Others slant the floor of the saw cabinet towards a dust collection port. Many just allow the sawdust to accumulate on the floor under the saw until you clean it out. You will always have some cleaning of the interior to do. Perhaps you won't wait until the sawdust has totally encased the trunnion gears packing itself up to the bottom of the table top. You will need to connect the saw to a dust collector through its dust port. The suction of the dust collector should be about 350 CFM for a 10" saw and more for a larger saw.
There is a rule that says, "Never stand directly behind a horse or a table saw." Sooner or later every table saw operator will do something stupid that causes a kickback. If the operator makes it a practice to avoid standing where the kickback will occur behind the blade, he or she will probably avoid the severe injury that can be inflicted by a flying piece of wood striking the face, neck, chest or arms of the woodworker.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
A hybrid table saw is a lot like the contractor saw with a few key differences. For one thing, it is much more compact than the contractor saw and does not require as much room in your tool shed. The hybrid table saw also offers some of the features of the cabinet saw. With its solid and heavy base, it has the lower vibration of a cabinet saw along with dust control. A contractor saw or a hybrid saw of good quality suits the needs of most woodworkers.
In the modern table saw, regardless of type, the depth of a cut is changed by adjusting the distance that the blade sticks out above the table surface. The more the blade protrudes from the table, the deeper the cut that is made in the material will be. Conversely, the less a blade protrudes from the table, the more shallow the cut that is made in the material being cut, will be.
Care to Shout Your Thoughts on Table Saw Station Plans Table Saw Router Station Plans Table Saw Station Plans Pdf Table Saw Workbench Plans Pdf New Yankee Workshop Table Saw Station Plans