Home / Table Saw / Table Saw Station Plans / Table Saw Station Plans Or Shopnotes Table Saw Workstation Plans With Tablesaw/router Station Plans Plus Mobile Table Saw Station Plans Together With Table Saw
John Frye Table Saw August 28th, 2018 - 10:28:32
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.
Woodworking can be a dangerous business. Always use a push stick or similar device. Fingers are not replaceable. Never try to rip narrow strips next to the fence. Instead, cut them off of the left side of the work piece. In this case, you would stand to the right of the blade. In short, think ahead about the possible complications of what you are about to do, keep your eyes wide open (wearing goggles, of course) and keep your wits about you at all times.
The ideal solution is to have enough shop space so that you will never have to move your saw around at all. In this situation, you can construct an outfeed table to support large work pieces and long lumber as they leave the back edge of the table saw table. Ideally, depending on space available, you should build this outfeed table so that it extends eight feet or more in back of the blade. You can use the space underneath the table for lumber storage and/or drawer space. The table can also serve as a work bench for the construction of large cabinets and tables. You can use it for pipe clamp glue-ups and spray painting layout, as well.
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
Beginning at the bottom, the table saw base houses the working parts of the saw, including the trunnions, the arbor assembly, the sector gears, and sometimes the motor. On some saws, the base is a "cabinet" type, meaning that a fully enclosed base extends all the way to the floor. Other saws have an open base, meaning that the base consists of a metal box that surrounds the internal working parts of the saw on four sides, but not the bottom. Open base saws have legs that extend downward from the bottom of the base to the floor.
Have Something to Say on Table Saw Station Plans Or Shopnotes Table Saw Workstation Plans With Tablesaw/router Station Plans Plus Mobile Table Saw Station Plans Together With Table Saw
Posts Related To Table Saw Station Plans