Cristina Joseph Table Saw August 28th, 2018 - 18:38:33
There is a rule that says, "Never stand directly behind a horse or a table saw." Sooner or later every table saw operator will do something stupid that causes a kickback. If the operator makes it a practice to avoid standing where the kickback will occur behind the blade, he or she will probably avoid the severe injury that can be inflicted by a flying piece of wood striking the face, neck, chest or arms of the woodworker.
In older table saw, altering the angle of the blade was used to increase or decrease the depth of the cut. Nowadays, there is still an adjustable angle control, but this is used merely to adjust the angle at which the material is cut, and is not used to decrease or increase the depth of cut being made.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.
The motor, trunnions, arbor assembly, and gearing make up the essential mechanical components of the saw. These quality and robustness of these components varies considerably and can greatly impact the durability of the saw, its capacity for cutting heavy stock and its ability to stay in adjustment and hold settings.
Leave Your Reply on Table Saw Blade Cut Width Thin Kerf Table Saw Blade Home Depot Table Saw Blade Width Thin Kerf Table Saw Blade Width Thin Kerf Table Saw Blade Lowes
Posts Related To Table Saw Blade Width