Luz Franks Table Saw August 28th, 2018 - 13:13:15
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.
At least one, but preferably two or more access doors should be provided leading into the cabinet of the table saw. The one you will use most often will be for cleaning out the interior of sawdust. Another should give easy access to the motor, trunnion and belts for adjustment and repair. Many saws provide a removable access panel instead of a second door. That's fine for occasional motor, arbor, belt and trunnion access but you will want the sawdust door to open and close easily.
The motor, trunnions, arbor assembly, and gearing make up the essential mechanical components of the saw. These quality and robustness of these components varies considerably and can greatly impact the durability of the saw, its capacity for cutting heavy stock and its ability to stay in adjustment and hold settings.
Many table saws can be purchased with optional extension wings. Table extension wings bolt on to the right and left sides of the table and increase the surface area of the saw to help support wide stock and sheet materials. On a heavy duty stationary saw, the extensions are usually cast iron, while on smaller saws, they may be made of lighter stamped steel or the lighter "webbed" style of cast iron.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.