Luz Franks Table Saw August 28th, 2018 - 13:44:53
The rip fence guides the wood as it is being ripped (cut along its length) and can be positioned to any width of cut within the saw's range. The fence rides on fence rails attached to the front and rear edge of the table. Ideally, the system keeps the fence perfectly parallel to the plane of the blade, regardless of where the fence is positioned.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
The quality of the table saw surface (or "bed") is extremely important to the overall performance of the machine. The table surface needs to be reliably flat and rigid to properly support the workpiece during a cut. As one of the most massive parts of the saw, the table surface also plays a major role in absorbing vibration. Because of the need for mass, rigidity and flatness, cast iron is the material of choice for the top of a table saw. On a quality saw, the table is made using a hefty quantity of cast iron and state-of-the-art foundry methods. The end result of the casting process is then precision ground to flatness in the .0005'' tolerance range.
Motor horsepower and blade size are closely related. The larger the blade, the more horsepower you will need to cut, at full blade height, through a piece of wood. Too much power is never a problem. Too little power can cause the saw to bind, slow down and even stop in the middle of a cut. This is not good, nor is it safe.
Care to Shout Your Thoughts on Delta Table Saw 36 6022 Delta 10 In Carbide Tipped 13 Amp Table Saw
Posts Related To Delta Table Saw 36 6022