Home / Table Saw / Delta Table Saw 36 6022 / Delta Table Saw 36 6022 Fence With Delta Table Saw 36 6022 Plus Delta Table Saw 36 6022 Parts Together With Delta Table Saw Model 36 6022 As Well As Delta 10
Luz Franks Table Saw August 28th, 2018 - 13:43:39
If you consider that a sheet of plywood measures 48" in width, I would think that you might want to opt for a 50-inch rip as opposed to the slightly less expensive 30" rip capacity. You might want to rip off only one inch from that sheet of plywood and, while doing that, you will want the plywood to be fully supported. You might want to crosscut a sheet of plywood into two 48" pieces. You also should consider the rip space to the left of the blade: The wider, the better. Sometimes, you might want to accomplish tasks that require the fence to be put over to the left side of the blade.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
The rip fence guides the wood as it is being ripped (cut along its length) and can be positioned to any width of cut within the saw's range. The fence rides on fence rails attached to the front and rear edge of the table. Ideally, the system keeps the fence perfectly parallel to the plane of the blade, regardless of where the fence is positioned.
Have Something to Say on Delta Table Saw 36 6022 Fence With Delta Table Saw 36 6022 Plus Delta Table Saw 36 6022 Parts Together With Delta Table Saw Model 36 6022 As Well As Delta 10
Posts Related To Delta Table Saw 36 6022