Luz Franks Table Saw August 28th, 2018 - 14:39:41
One of the more useful add-ons for just about any table saw is either an upgraded system offered by the manufacturer, or an aftermarket miter gauge or crosscutting sled. These tools provide, in various combinations, repeatable incremental angle positioning, longer fences, stop blocks and other advanced features that can come in handy in projects that call for precision crosscutting.
Motor horsepower and blade size are closely related. The larger the blade, the more horsepower you will need to cut, at full blade height, through a piece of wood. Too much power is never a problem. Too little power can cause the saw to bind, slow down and even stop in the middle of a cut. This is not good, nor is it safe.
The size of the cast iron table saw top is also important: the larger the better. When you are sawing large objects, you want as much flat table surface as you need to support the work piece flat to the blade for accuracy. Larger table size is usually accomplished by attaching cast-iron table wings to the edge of the main table. These wings must be as flat as the table and the seam they create must be aligned so that the top of the wing is flush to the table saw table along its entire length.
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
Most table saws - other than small bench top models - are equipped with induction type motors in the 1 - 5 HP range. On larger saws, you'll most often find a "totally enclosed, fan cooled" (TEFC) induction motor. A TEFC motor is designed for continuous duty and is sealed against dust and other contaminants - a significant advantage in a woodshop.
Leave Your Reply on Delta Table Saw 36 6022 Delta Table Saw 36 6022 Fence Delta 10 Inch Table Saw 36 6022 Delta Table Saw 36 6022 Parts Delta Table Saw Model 36 6022