Luz Franks Table Saw August 28th, 2018 - 14:09:29
Many table saws can be purchased with optional extension wings. Table extension wings bolt on to the right and left sides of the table and increase the surface area of the saw to help support wide stock and sheet materials. On a heavy duty stationary saw, the extensions are usually cast iron, while on smaller saws, they may be made of lighter stamped steel or the lighter "webbed" style of cast iron.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
A table saw is the most common piece of large woodworking equipment found in shops around the world. Table saw are very versatile, and if you can only have one piece of woodworking equipment, a rigid table saw is probably the best one to choose. These more portable types of table saws offer versatility and ease of use with the convenience of portability.
Another important safety device is the magnetic switch. This device protects you after an electrical power failure. If the power fails and you have a regular switch, the saw will come back on when the power comes back on. If you were to be near the blade at the time, this could be disastrous. A magnetic switch will not allow the saw to start again until you press the button. The location of the switch is also important. It should be right out front where it can be quickly accessed by a hand, foot or knee in the event of an emergency. The off button should be wide, red in color and should extend outside of the switch box like a mushroom for fast access.
The size of the cast iron table saw top is also important: the larger the better. When you are sawing large objects, you want as much flat table surface as you need to support the work piece flat to the blade for accuracy. Larger table size is usually accomplished by attaching cast-iron table wings to the edge of the main table. These wings must be as flat as the table and the seam they create must be aligned so that the top of the wing is flush to the table saw table along its entire length.
Have Something to Say on Delta Table Saw 36 6022 Shop Fow1820 Table Saw With Extension Table