Home / Table Saw / Hitachi 10 Inch Table Saw / Hitachi 10 Inch Table Saw Or Hitachi 10 Inch Jobsite Table Saw With Hitachi C10rb 10 Inch Portable Jobsite Table Saw With Stand Plus Hitachi 10 Inch Table Saw
Luz Franks Table Saw August 28th, 2018 - 13:04:54
In the modern table saw, regardless of type, the depth of a cut is changed by adjusting the distance that the blade sticks out above the table surface. The more the blade protrudes from the table, the deeper the cut that is made in the material will be. Conversely, the less a blade protrudes from the table, the more shallow the cut that is made in the material being cut, will be.
The rip fence guides the wood as it is being ripped (cut along its length) and can be positioned to any width of cut within the saw's range. The fence rides on fence rails attached to the front and rear edge of the table. Ideally, the system keeps the fence perfectly parallel to the plane of the blade, regardless of where the fence is positioned.
My ideal would be to never have a speck of dust reach the gears of my table saw trunnion and that all sawdust would be sucked away from the saw blade and out of the machine as soon as it was made. I would never need to clean out sawdust from inside the saw cabinet and the trunnion would always operate smoothly and easily. While I don't expect to ever see my dream fully realized, there are saws on the market today that closely approach this level of efficiency in sawdust extraction.
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
Care to Shout Your Thoughts on Hitachi 10 Inch Table Saw Or Hitachi 10 Inch Jobsite Table Saw With Hitachi C10rb 10 Inch Portable Jobsite Table Saw With Stand Plus Hitachi 10 Inch Table Saw