Edith Hart Table Saw August 28th, 2018 - 13:39:44
The ideal solution is to have enough shop space so that you will never have to move your saw around at all. In this situation, you can construct an outfeed table to support large work pieces and long lumber as they leave the back edge of the table saw table. Ideally, depending on space available, you should build this outfeed table so that it extends eight feet or more in back of the blade. You can use the space underneath the table for lumber storage and/or drawer space. The table can also serve as a work bench for the construction of large cabinets and tables. You can use it for pipe clamp glue-ups and spray painting layout, as well.
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
If you are looking for a machine that can aid you in making straight cuts or doing cut offs on your wooden furniture and fixtures at home, a table saw is definitely what you need.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
Most table saws - other than small bench top models - are equipped with induction type motors in the 1 - 5 HP range. On larger saws, you'll most often find a "totally enclosed, fan cooled" (TEFC) induction motor. A TEFC motor is designed for continuous duty and is sealed against dust and other contaminants - a significant advantage in a woodshop.
Care to Shout Your Thoughts on Old Rockwell Table Saw And Old Rockwell Table Saw With Old Delta Rockwell Table Saw Parts Plus Vintage Delta Rockwell Table Saw Parts Together With Old
Posts Related To Old Rockwell Table Saw