Jessie Hughes Table Saw July 31st, 2018 - 10:34:27
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.
A hybrid table saw is a lot like the contractor saw with a few key differences. For one thing, it is much more compact than the contractor saw and does not require as much room in your tool shed. The hybrid table saw also offers some of the features of the cabinet saw. With its solid and heavy base, it has the lower vibration of a cabinet saw along with dust control. A contractor saw or a hybrid saw of good quality suits the needs of most woodworkers.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
The cabinet saw, contractor saw, hybrid saw, and bench top saw are all types of table saws that will help you in your woodworking projects. Each saw is slightly different to accommodate the certain needs of the woodworker. One must find what they need out of there table saw before determining what type of model they need. However, for the average woodworking projects, you cannot go wrong with a quality contractor saw.
Some of the nicer table saws have the caster wheels permanently mounted inside the cabinet so they are never seen and are never in the way. A foot pedal controls raising the saw up into the mobility position and then lowering it back down onto the floor. If your table saw does not have this feature, after-market mobility bases can be purchased as needed.