Irene Mendoza Table Saw August 18th, 2018 - 21:23:48
One table saw manufacturer I know believes in "aging" its cast iron machine table tops before milling them flat. The tops are cast and then left outside in a "bone yard" to bend, bow, warp and twist in the sun and rain for a year or so. Then, they are brought inside where all the rust is removed and the table top is ground absolutely flat and polished to sheen. The theory is that the metal needs to settle into a place where all post-casting movement has ceased and that the table should not be ground flat before this is done. Otherwise, the table may move out of absolute flatness after it is part of your new table saw and that it not at all desirable. Why? Because the flatness of your table saw top will determine the accuracy of your cuts. Be sure to check your new table saw for table flatness with a straightedge on or before delivery and afterwards from time to time. Lay the rule across the table top at all angles and check for daylight under the rule or rocking of the straightedge on the table top.
Most table saws use the miter gauge and miter slot system to allow for crosscutting. A miter gauge consists of a cast metal protractor head attached to a length of metal bar. The bar rides in corresponding "miter slot" in the table saw's surface. Protractor on the "no frills" miter gauges that come with most table saws can be set to crosscut stock at any angle between 90 and 30 degrees and, if well made, do a serviceable job with most "routine" crosscutting.
The rip fence guides the wood as it is being ripped (cut along its length) and can be positioned to any width of cut within the saw's range. The fence rides on fence rails attached to the front and rear edge of the table. Ideally, the system keeps the fence perfectly parallel to the plane of the blade, regardless of where the fence is positioned.
There is a rule that says, "Never stand directly behind a horse or a table saw." Sooner or later every table saw operator will do something stupid that causes a kickback. If the operator makes it a practice to avoid standing where the kickback will occur behind the blade, he or she will probably avoid the severe injury that can be inflicted by a flying piece of wood striking the face, neck, chest or arms of the woodworker.
Many table saws can be purchased with optional extension wings. Table extension wings bolt on to the right and left sides of the table and increase the surface area of the saw to help support wide stock and sheet materials. On a heavy duty stationary saw, the extensions are usually cast iron, while on smaller saws, they may be made of lighter stamped steel or the lighter "webbed" style of cast iron.
Have Something to Say on The Ultimate Table Saw Fence 6 Steps With Pictures Picture Of The Ultimate Table Saw Fence
Posts Related To Aftermarket Rip Fences For Table Saws