Gwen Page Table Saw July 31st, 2018 - 07:44:48
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
A hybrid table saw is a lot like the contractor saw with a few key differences. For one thing, it is much more compact than the contractor saw and does not require as much room in your tool shed. The hybrid table saw also offers some of the features of the cabinet saw. With its solid and heavy base, it has the lower vibration of a cabinet saw along with dust control. A contractor saw or a hybrid saw of good quality suits the needs of most woodworkers.
Most table saws use the miter gauge and miter slot system to allow for crosscutting. A miter gauge consists of a cast metal protractor head attached to a length of metal bar. The bar rides in corresponding "miter slot" in the table saw's surface. Protractor on the "no frills" miter gauges that come with most table saws can be set to crosscut stock at any angle between 90 and 30 degrees and, if well made, do a serviceable job with most "routine" crosscutting.
If you're in the market for a table saw, you'll have a number of options and features to consider. To make the best decision, a basic understanding of the "inner workings" of this woodshop standard is essential. Below, I'll describe the primary table saw components, what makes them important, and what to look for when it comes time to buy.
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.