Carla Cain Table Saw July 30th, 2018 - 18:11:39
If you consider that a sheet of plywood measures 48" in width, I would think that you might want to opt for a 50-inch rip as opposed to the slightly less expensive 30" rip capacity. You might want to rip off only one inch from that sheet of plywood and, while doing that, you will want the plywood to be fully supported. You might want to crosscut a sheet of plywood into two 48" pieces. You also should consider the rip space to the left of the blade: The wider, the better. Sometimes, you might want to accomplish tasks that require the fence to be put over to the left side of the blade.
Motor horsepower and blade size are closely related. The larger the blade, the more horsepower you will need to cut, at full blade height, through a piece of wood. Too much power is never a problem. Too little power can cause the saw to bind, slow down and even stop in the middle of a cut. This is not good, nor is it safe.
Some of the nicer table saws have the caster wheels permanently mounted inside the cabinet so they are never seen and are never in the way. A foot pedal controls raising the saw up into the mobility position and then lowering it back down onto the floor. If your table saw does not have this feature, after-market mobility bases can be purchased as needed.
If you're in the market for a table saw, you'll have a number of options and features to consider. To make the best decision, a basic understanding of the "inner workings" of this woodshop standard is essential. Below, I'll describe the primary table saw components, what makes them important, and what to look for when it comes time to buy.
In older table saw, altering the angle of the blade was used to increase or decrease the depth of the cut. Nowadays, there is still an adjustable angle control, but this is used merely to adjust the angle at which the material is cut, and is not used to decrease or increase the depth of cut being made.