Edith Hart Table Saw August 15th, 2018 - 16:06:20
A hybrid table saw is a lot like the contractor saw with a few key differences. For one thing, it is much more compact than the contractor saw and does not require as much room in your tool shed. The hybrid table saw also offers some of the features of the cabinet saw. With its solid and heavy base, it has the lower vibration of a cabinet saw along with dust control. A contractor saw or a hybrid saw of good quality suits the needs of most woodworkers.
At least one, but preferably two or more access doors should be provided leading into the cabinet of the table saw. The one you will use most often will be for cleaning out the interior of sawdust. Another should give easy access to the motor, trunnion and belts for adjustment and repair. Many saws provide a removable access panel instead of a second door. That's fine for occasional motor, arbor, belt and trunnion access but you will want the sawdust door to open and close easily.
The table saw is the heart of your shop. You will use it more than any other machine and its accuracy and capacity will determine the quality and size of what you will be able to produce. This is akin to picking someone to marry: Ideally, it's for life and you will have to live with your decision for a long time to come. Therefore, rushing into purchasing the first table saw you see, without doing your homework, is like a quickie Las Vegas marriage, always a gamble.
Some of the nicer table saws have the caster wheels permanently mounted inside the cabinet so they are never seen and are never in the way. A foot pedal controls raising the saw up into the mobility position and then lowering it back down onto the floor. If your table saw does not have this feature, after-market mobility bases can be purchased as needed.
If you consider that a sheet of plywood measures 48" in width, I would think that you might want to opt for a 50-inch rip as opposed to the slightly less expensive 30" rip capacity. You might want to rip off only one inch from that sheet of plywood and, while doing that, you will want the plywood to be fully supported. You might want to crosscut a sheet of plywood into two 48" pieces. You also should consider the rip space to the left of the blade: The wider, the better. Sometimes, you might want to accomplish tasks that require the fence to be put over to the left side of the blade.