Willa Delaney Table Saw August 28th, 2018 - 16:17:23
The smallest motor I would even consider for a 10-inch saw would be 3 horsepower. For a 12" to 14" saw it would be 5HP and for a 14" to 16" saw, I'd like 7.5 HP. You will also need to consider if the saw motor is single or three phase. Three phase motors use electricity a bit more efficiently. If you don't have three phase power at your location, however, you will either have to buy single phase or purchase and install a phase converter large enough for your saw motor. Most saw motors use 230 or 460 VAC power, so make sure you have available in your shop the voltage your saw will require. Three phase motors can run on 208 to 220 volts or higher, depending on the motor.
The fence must be aligned so that the front of the blade and the rear of the blade are exactly the same distance from the fence at all settings. Once you have ascertained that the blade and fence are parallel to each other, you must cut some test boards to accurately set the fence to the scale. Set the fence to exactly 2" on the measuring scale. Rip a test board and measure it. Adjust the fence to the scale by moving the viewer's hairline left or right. Rip more boards until you have exact accuracy. The viewer through which you see the tape should be strong in magnification.
One of the more useful add-ons for just about any table saw is either an upgraded system offered by the manufacturer, or an aftermarket miter gauge or crosscutting sled. These tools provide, in various combinations, repeatable incremental angle positioning, longer fences, stop blocks and other advanced features that can come in handy in projects that call for precision crosscutting.
This second type of table saw is heavier and bigger in size compared to the first one. But still it can be relocated everywhere in work location. With this reason, it is definitely more durable and its work capability is more efficient. This is reasonably priced also has an attached rest or stand but also comes in wheels. This is recommended especially for homeowners who have standard electrical circuits which are needed to handle sufficient power to operate it. This is also certainly for you if you have a tool shack in your home.
Your new saw must have a rip capacity equal or wider than the widest thing you will ever want to rip. Usually, a cabinet saw will have a rip capacity of around 30 inches or 50 inches. A large rip capacity to the right of the blade will require an extension table to support work wider than the cast iron table. Many times, this extension table is included with the saw or, alternatively, you can easily build you own. The fence must have a tube or rail long enough to achieve the maximum with you want to rip.
Have Something to Say on Make A Table Saw Sled Part 1 Youtube
Posts Related To Table Saw Sled Plans Free