Home / Table Saw / Table Saw Sled Plans Free / Table Saw Sled Plans Free Table Saw Sled Plans Free Table Saw Miter Sled Plans Free Table Saw Crosscut Sled Plans Free Table Saw Sled Plans Free Pdf Build A
Willa Delaney Table Saw August 28th, 2018 - 16:04:48
Also known as the open-stand saw, the contractor saw is heavier and more durable than the bench top saw. Its circular saw is mounted on a heavy table with an open set of legs. This type of saw is usually preferred for those who have a tool shed at home since it is moderately-priced and does not require any extra voltage than is provided in a regular outlet. While this model is heavier and less portable than the bench top model, the contractor table saw is still usually moved from job to job (most contractor saws come with wheel attachments to make this easier).
The motor, trunnions, arbor assembly, and gearing make up the essential mechanical components of the saw. These quality and robustness of these components varies considerably and can greatly impact the durability of the saw, its capacity for cutting heavy stock and its ability to stay in adjustment and hold settings.
Another important safety device is the magnetic switch. This device protects you after an electrical power failure. If the power fails and you have a regular switch, the saw will come back on when the power comes back on. If you were to be near the blade at the time, this could be disastrous. A magnetic switch will not allow the saw to start again until you press the button. The location of the switch is also important. It should be right out front where it can be quickly accessed by a hand, foot or knee in the event of an emergency. The off button should be wide, red in color and should extend outside of the switch box like a mushroom for fast access.
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
Care to Shout Your Thoughts on Table Saw Sled Plans Free Table Saw Sled Plans Free Table Saw Miter Sled Plans Free Table Saw Crosscut Sled Plans Free Table Saw Sled Plans Free Pdf Build A
Posts Related To Table Saw Sled Plans Free