Johanna Soto Table Saw August 11th, 2018 - 07:16:49
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
A few recent additions to the table saw market combine features of cabinet-base saws and open-base saws. These "hybrid" saws have both a completely enclosed base and legs. The small, enclosed base of the hybrid saw promotes dust collection and limits noise. A popular choice for hobbyist and small professional shops, hybrid table saws are also lighter and more affordable than traditional cabinet table saws.
Your new saw must have a rip capacity equal or wider than the widest thing you will ever want to rip. Usually, a cabinet saw will have a rip capacity of around 30 inches or 50 inches. A large rip capacity to the right of the blade will require an extension table to support work wider than the cast iron table. Many times, this extension table is included with the saw or, alternatively, you can easily build you own. The fence must have a tube or rail long enough to achieve the maximum with you want to rip.
The quality of the table saw surface (or "bed") is extremely important to the overall performance of the machine. The table surface needs to be reliably flat and rigid to properly support the workpiece during a cut. As one of the most massive parts of the saw, the table surface also plays a major role in absorbing vibration. Because of the need for mass, rigidity and flatness, cast iron is the material of choice for the top of a table saw. On a quality saw, the table is made using a hefty quantity of cast iron and state-of-the-art foundry methods. The end result of the casting process is then precision ground to flatness in the .0005'' tolerance range.
Needless to say, the table must be exactly the same height as the top of the table saw table and you may need to extend the slots for the miter gauge into the beginning of the top of the outfeed table. If your saw extension table extends 50 inches or so to the right of the blade, so should your outfeed table and it should extend along the entire back edge of the table saw to the left of the blade. The saw should ideally be oriented so that you can bring long lumber through the shop door and directly onto the saw table without having to turn a corner.