Home / Table Saw / Craftsman 137 Table Saw / Craftsman 10 Inch Table Saw Model 137 Manual With Craftsman Table Saw Model 137 Parts Plus Craftsman 137 Table Saw Fence Together With Craftsman 137 Table Saw
Jessie Hughes Table Saw August 28th, 2018 - 11:58:47
Most table saw trunnions are made to tilt either left or right (but not both) to a maximum of 45 degrees from vertical. If you have a choice, and you usually do, never buy a right-tilt saw for the following reason. A right-tilt saw tilts the blade towards the fence and can pinch a work piece into the fence, causing a jam or, worse, a kickback just as the cut is finishing. Further, on a right-tilt saw, the blade is tilting towards the fence and could cut into and ruin it if the fence were to be inadvertently moved too close to the spinning blade. A left-tilt saw tilts away from the fence and instead of pinching the work piece, allows it to rise vertically slightly, if need be.
My ideal would be to never have a speck of dust reach the gears of my table saw trunnion and that all sawdust would be sucked away from the saw blade and out of the machine as soon as it was made. I would never need to clean out sawdust from inside the saw cabinet and the trunnion would always operate smoothly and easily. While I don't expect to ever see my dream fully realized, there are saws on the market today that closely approach this level of efficiency in sawdust extraction.
Most table saws - other than small bench top models - are equipped with induction type motors in the 1 - 5 HP range. On larger saws, you'll most often find a "totally enclosed, fan cooled" (TEFC) induction motor. A TEFC motor is designed for continuous duty and is sealed against dust and other contaminants - a significant advantage in a woodshop.
Most table saws use the miter gauge and miter slot system to allow for crosscutting. A miter gauge consists of a cast metal protractor head attached to a length of metal bar. The bar rides in corresponding "miter slot" in the table saw's surface. Protractor on the "no frills" miter gauges that come with most table saws can be set to crosscut stock at any angle between 90 and 30 degrees and, if well made, do a serviceable job with most "routine" crosscutting.
One drawback of lighter-weight table extensions is that they have less mass, and the overall mass of the saw is what soaks up the vibration crated by the motor and other moving parts. The added mass of heavy cast iron extension wings decreases vibration, which in turn helps the saw stay in calibration, and also helps it stay planted firmly on the shop floor. On less expensive saws, extensions made of stamped metal, or ones that aren't precision ground, can also compromise the overall flatness of the table surface.
Leave Your Reply on Craftsman 10 Inch Table Saw Model 137 Manual With Craftsman Table Saw Model 137 Parts Plus Craftsman 137 Table Saw Fence Together With Craftsman 137 Table Saw