Tammy Branch Table Saw August 18th, 2018 - 07:11:17
Some saws shield the blade in a casing underneath the saw table and suck the dust out directly from there. Others slant the floor of the saw cabinet towards a dust collection port. Many just allow the sawdust to accumulate on the floor under the saw until you clean it out. You will always have some cleaning of the interior to do. Perhaps you won't wait until the sawdust has totally encased the trunnion gears packing itself up to the bottom of the table top. You will need to connect the saw to a dust collector through its dust port. The suction of the dust collector should be about 350 CFM for a 10" saw and more for a larger saw.
The saw blade is mounted on an arbor with an arbor nut and the arbor is turned by the motor usually via pulleys and 1 to 3 V-belts. The arbor is mounted into the trunnion inside two or more arbor bearings. These should be sealed from dust for obvious reasons. The size of the arbor determines the size of the hole in the middle of the saw blade. This is usually 5/8" for a 10" blade and 1" or larger for blades larger than that. The strength and alignment of the arbor and the bearings which support it determine the accuracy and smoothness of the table saw. Vibration and noise should be kept to a minimum and the saw blade should be straight in the table from front to back at all elevations and bevel angles.
The quality of the table saw surface (or "bed") is extremely important to the overall performance of the machine. The table surface needs to be reliably flat and rigid to properly support the workpiece during a cut. As one of the most massive parts of the saw, the table surface also plays a major role in absorbing vibration. Because of the need for mass, rigidity and flatness, cast iron is the material of choice for the top of a table saw. On a quality saw, the table is made using a hefty quantity of cast iron and state-of-the-art foundry methods. The end result of the casting process is then precision ground to flatness in the .0005'' tolerance range.
Your new saw must have a rip capacity equal or wider than the widest thing you will ever want to rip. Usually, a cabinet saw will have a rip capacity of around 30 inches or 50 inches. A large rip capacity to the right of the blade will require an extension table to support work wider than the cast iron table. Many times, this extension table is included with the saw or, alternatively, you can easily build you own. The fence must have a tube or rail long enough to achieve the maximum with you want to rip.
The bench top model is preferred for those who are looking for a table saw that is portable and less expensive; however, remember that you always get what you pay for. The bench top saw has the least amount of capability out of any of the table saws. With the decreased size and weight of the saw, it is less durable and there are greater restrictions of the size of projects one can do.